We're proud of these new digital Wing servos. Their combination of high speed and torque is attractive. But they really set the bar in terms of extremely accurate centering, high-strength low-lash metal drive gears, and resistance to change in trim over a wide temperature range. Double ball bearing keep it all smooth.
In addition, the well-designed mounting tabs allow the use of M3 self-tapping screws to secure the servo to either hardwood blocks, or built-up posts of epoxy-fiberglass. Each box includes one servo, a variety of servo arms, mounting screws, and programming information sheet.
DS095 WING are certified for use with Hyperion LiFePO4 receiver packs.
Speed sec/60 deg 4.8v/6.0 0.18/0.15
Dynamic torque Kg/cm 4.8/6.0v 4.0/4.5
Holding torque Kg/cm 4.8v/6.0v 8.0/9.0
Dimensions mm 31.5x9.5x32.7
Gear Train Primary Material Metal
Bearing Double ball
Operating Temp -10 to +60 Degree C
Current Drain (4.8V) 6.0mA / 170mA
Current Drain (6.0V) 6.0mA / 200mA
Stall Current (4.8V) 750mA
Stall Current (6.0V) 900mA
Minimum Input Voltage 3.5V under load
Maximum Input Voltage unloaded 7.3V / loaded 6.3V
Connector Wire Gauge 25AWG
Connector Wire Length 60mm
Connector Wire Strand Count 30EA