*Does not fit Trex EFL
RC Aerodyne feels that scale does not have to just stop at the outer fuselage. We are pushing the limits and including special designed side frames that allow you to keep all your mechanics up on top in the dog house.
All you need is a flying Trex 600ESP or Chaos 600 torque tube model.
That's right, the Bell 212 kit incorporates a torque tube drive tail system. The first of its kind. Just like the real helicopters, this drive system is extremely reliable, maintenance free and is extremely quick to install. No more adjusting, tightening belts, and lubricating drive systems. This is a plug n play system and is a dream to install.
The special designed side frames are designed to offer 2 unique features.
1. To lower the transmission allowing for the torque tube to travel thru the lower tail boom
of the helicopter. This has always been an issue with mostly military helicopters.
2. Probably the most revolutionary design in scale helicopters, these frames allow the entire
mechanical system to be tucked up inside the dog house just like the real helicopters.
This allows for a truly scale helicopter. Normally the mechanics would take up the entire
fuselage area, leaving no room for cockpits, rear seats etc.. That's all changed with
RC Aerodyne's new frame design.
* Note, This does not fit the Trex 600 Pro EFL models
Most of the work is done for you. Pre-drilled holes for easy install of landing gear.
All wood work is installed.
Beautifully painted fiberglass fuselage
Scale cockpit is completely hand assembled and painted for you. All you need to do is just slide it in. No more stickers, each cockpit is hand painted with raised details and instruments. * Cockpit sold separately.
Power set up:
Because the Bell 212 is a 2 blade helicopter, there is no need to change any configuration within the mechanics. If you have a healthy flying 600 helicopter, you will not need to upgrade or change anything.
Standard 600 set up is a 1100 kv out runner 40mm motor
80-100 amp esc
6s 5000 or higher mah battery pack with a " C " rating of 25 or higher.Specification:
●Body length:1480mm ( 58.25 " )
●Body width:330mm ( 13 " )
●Body high:280mm (11 " )
●Bell 212 Scale Fuselage
●Shaf Driven Elevated Tail Rotor Set
●Water Transfer Decals
Cockpit Sold Separately
Flying 600 Chaos/Trex/Variant - * must have torque tube drive system
Scale Rotor Head Sold Separately
Download the Instruction Manual (Acrobat PDF)